The Titan telescoping flagpole manufactured in the US is one of the finest flags, made of nylon, and comes up in a kit. It comes with a telescoping flagpole, an effectively sized flag, hardware to fly two flags, a ball topper, and a ground sleeve.
And you can find the below steps to install a flagpole
Step #1
Follow instructions completely. Choose the location for your
flagpole and be sure that there are no impediments, utilities or power lines
lower than the surface or overhead.
Step #2: Dig a circular “Fence Post Size” hole, 16” in length and
30” deep. A longer hole may be mandatory for smooth or sandy soil
Step #3: For sure that hole is at least the size confirmed in the
previous step. Now shovel in 5”-7” of gravel into the end of the hole. This
will give water drainage.
Step #4: Set up the stop bolt completely through the pre-drilled
hole in the ground sleeve. Hand tightens only. Mix the concrete material
according to the manufacturer’s guidelines.
Step #5: Push the sleeve “into” the gravel while doing sure that
the floor sleeve is at least 1” above ground-level. If you go wrong to push the
sleeve into the gravel, it will allow the concrete to close the hole and avoid
water drainage.
Step #6: Utilize your “red cap” to protect the ground sleeve.
Start to shovel the concrete into the hole around the ground sleeve being
prudent not to spoil the sleeve position.
Step #7: Take-off the red cap to check the sleeve for plumb with a
level in multiple places. Install the red cap into the sleeve to avoid foreign
objects from entering sleeve.
Step #8: Later 24 hours of drying time, remove the red cap,
replace your flagpole into the hole.
Contact Us
31148 Oakview Rd, Bulverde, TX 78163
(210) 310-3524 or (877) 598-3524
sales@ameritexflags.com
NOTE: THIS IS NOT A RETAIL STORE.
This is a home based business. Please call first.
web: https://www.ameritexflags.com/products/20-ft-telescoping-flag-pole-titan.html
No comments:
Post a Comment